Profil public szcx18

Mercredi 24 juin 2015

Quantité : 1 - Prix : 1,00 €

1. Figure 1-Test Probe A 2.Figure 2 Test Probe B 3. Figure 3 Test Probe C 4. Figure 4 Test Probe D 5. Figure 5 Test Probe 1 6. Figure 6 Test Probe 2 7. Figure 7 Test Probe 11 8. Figure 8 Test Probe 12 9. Figure 9 Test Probe 13 10. Figure 10 Test Probe 14 11. Figure 11 Test...

Vendredi 19 juin 2015

Quantité : 10sets - Prix : USD3500/set

Tracking Tester according to IEC60112-2003 Tracking Test Chamber is intended for determining the degree of protection against formation of conducting paths in solid insulating materials, due to the electric stress and electrolytic contamination of the surface. This method simulates...

Vendredi 19 juin 2015

Appliance Stability Tester The device is used to test the stability of an apparatus that requires a surface in order to work, and confirm to the IEC60335-1 clause 20.1. The device consists of a surface and an angle adjusting device, with angles 0~15° adjustable. The appliance is...

Vendredi 19 juin 2015

Quantité : 2sets - Prix : USD6200/set

Spring Hammer Impact Calibration Device Principle of calibration: The principle of this calibration procedure is to compare the energy provided by a spring hammer, which is difficult to measure directly, to the energy of a pendulum, calculated from its mass and height of fall....

Vendredi 19 juin 2015

The TPK-05 was designed to provide the probes required by UL / IEC / EN 60529, the IP Code standard. It includes the following: - IEC Jointed Finger Probe (w/ banana jack in handle) (TFP-01) - 2.5 mm Test Rod (TRP-01) - 1.0 mm Test Wire (TRP-02) - Test Sphere Probe with handle...