4|CEO|SOLVENT - 1292 Annonces

Jeudi 11 juillet 2019

First, the purpose of the request The colorectal flora in water was determined by the membrane method. Second, the basic principles The filter membrane method uses a filter to filter the water sample, and the bacteria are trapped on the filter membrane, and then the filter membrane...

Mercredi 10 juillet 2019

According to the research from the United States Department of Agriculture, the QuEChERS meth od which extracts pesticide from foods is fast, convenient, cheap, effective and secure. When it compares to the traditional SPE method, QuEChERS not only uses less solvent but also adopts...

Mercredi 10 juillet 2019

Cellulose extraction thimbles are widely used in Soxhlet extractors. Soxhlet extraction is a widely used technology to analyze lipids or pesticides in food and soil materials and others. Soxhlet extraction is the continuous extraction of the required components in the solid mixture...

Mercredi 10 juillet 2019

A bottle-top dispenser is a device installed at the mouth of a solvent bottle to take a large amount of solution and has been constantly updated and improved to meet the growing operational requirements of the laboratory for more than ten years. There are two kinds of bottle-top dispensers...

Mardi 09 juillet 2019

Melt-blown filter cartridges are shaped filter cartridges, which made of non-toxic and odorless polypropylene particles after heating, melting, spinning, traction. Melt-blown filter cartridges are not only used in water purification, but also have excellent chemical compatibility...

Mardi 09 juillet 2019

First, the purpose of the request The colorectal flora in water was determined by the membrane method. Second, the basic principles The filter membrane method uses a filter to filter the water sample, and the bacteria are trapped on the filter membrane, and then the filter membrane...

Lundi 08 juillet 2019

As a simple and fast absorption chromatography technique for the routine purification of organic compounds, flash chromatography is developed for the daily purification of reaction products in the lab, which is low costs and achieves separations of samples (0.01-10.0 g weight) in short time...

Lundi 08 juillet 2019

HPLC is the separation of sample components between the column packing and the mobile phase for mass exchange. Therefore, the mobile phase is required to have the following characteristics: a. the flow relative to the sample has a certain solubility, to ensure that the sample components...

Vendredi 05 juillet 2019

Hawach scientific is a professional vacuum pump manufacturers, product quality through a number of international standards, and exported to more than 120 countries all over the world. More detail information and quotation about the products contact with info@hawach.com. Diaphragm...

Vendredi 05 juillet 2019

Generally speaking, bottle-top dispenser which is a scientific device could improve the wide application, safety performance, speed and reliability. In addition, it could save your time and work, even protect you and your samples. To be more specific, the advantages of the bottle-top...

Jeudi 04 juillet 2019

Flash column chromatography method is to separate the constituents from the mixture and thus purify it. In a word, flash column chromatography makes the samples go through the column which is filled with gel to achieve separation. In the beginning, the founder of flash column chromatography, Mr...

Jeudi 04 juillet 2019

Brief introduction of the capsule filter The bag filter is also called abandoned filter. Its shell is made of high-temperature polypropylene material. The inner filter core is made of folded filter core welded together by hot fusion. It is suitable for filtering small doses of liquid...

Jeudi 04 juillet 2019

(1) When loading and unloading or replacing the HPLC columns, the action should be light and the joint should be tightened properly. Strong mechanical vibration must be prevented to avoid voids in the bed. (2) If the instrument is used for routine analysis, the sample type is limited...

Jeudi 04 juillet 2019

Activation, also known as solvation, add a suitable solvent to expand the functional groups on the adsorbent and remove possible interferences on the adsorbent. Equilibrium, remove the activated solvent to create a suitable solvent environment for sampling. Usually, use the same solvent...

Mercredi 03 juillet 2019

Flash column chromatography is an efficient way to separate complex mixtures of compounds in the lab. we use compressed air to push the solvent through the column when we are running flash columns. It can help provide better separation and cut down the running time as while. Flash...

Mercredi 03 juillet 2019

Capsule filters are available in various sizes and can be autoclaved, which have four interfaces, two of which inlet and outlet of the filtered liquid are in the middle. One of the two sides is a vent, the other is a drain. Features of capsule filters 1. 1/4 male thread interface...

Mardi 02 juillet 2019

The average sample addition recovery rate of QuEChERS method is higher than 85%, with fewer impurities interfering with the detection of the target substance, a small amount of solvent, simple and fast operation, which will be the preferred pretreatment method for routine detection...

Mardi 02 juillet 2019

In this article, we want to clarify the syringe filter. Each of the different syringe filters is applied to the specific product Which the various syringe filter is worth seeing more and what are the right steps and methods to have a try. Classification by membrane The filtration...

Mardi 02 juillet 2019

The key to regenerating contaminated HPLC columns is to know the nature of the contaminants and to find the right solvent to remove. If contamination is caused by the accumulation of strongly retained materials during repeated injections, simple steps to remove these contaminants...

Lundi 01 juillet 2019

After selecting the type of SPE cartridges, we have to determine the specifications of the SPE cartridge. The principle of selecting the SPE cartridge specification is to first ensure that the SPE cartridge packing has sufficient capacity to retain the target compound 100% on the column...

Samedi 22 juin 2019

Hi, This is CEO, Eric Chou from TAIWAN DING LI INT'L DEV. LTD, Located in Taichung City ,TAIWAN , We have a factory with 1500 Square meters ,we are specialized in the Amusement Indoor machine and Foosball tables , If you have purchase plans recently , hope to have a win-win Cooperation with you...

Vendredi 21 juin 2019

1. Capacity setting For the adjustable pipette, it is usually operated in the range of 10% to 100%. The optimal pipetting capacity is in the range of 35% to 100%. At this time, it is less affected by the operation technique and can better protect the pipetting. Accuracy and precision...

Vendredi 21 juin 2019

We can always hear such a conversation between those researchers. “Hey, buddy, what is your purity degree of the end products today?” “Damn it. Such a low degree that I cannot even use for the next step. Any better methods for clarifying raw materials?” Then there comes Hawach syringe filter...

Vendredi 21 juin 2019

The material of the nylon membrane filter is aliphatic nylon. It has good hydrophilicity, the appropriate concentration of acid and alkali resistant, and applies not only acid and alkaline aqueous solution, but also suitable for organic solvent, such as s, hydrocarbon, ethers, esters...

Vendredi 21 juin 2019

Normally SPE cartridge has two basic adsorption modes: target compound adsorption mode, impurity adsorption mode; 5 operation modes: gravity operation, manual positive pressure, centrifuge, negative pressure and positive pressure mode. Now let's review the whole process step by step...

Jeudi 20 juin 2019

Basic Knowledge of Vacuum Filtration Based on the principle that under the same pressure (vacuum degree), the vaporization temperature of the water is lower than that of oil, scientists make practical equipment which is called vacuum filter. In fact, vacuum filtration is the most...

Jeudi 20 juin 2019

Suitable for Soxhlet-type and other similar devices, the extraction thimbles are used to adapt a sample of solid material to extract certain components out, with the addition of sufficient and appropriate solvent. Cellulose extraction thimbles which are made of high-quality alpha...

Jeudi 20 juin 2019

Firstly, let's divide those bottle-top dispensers into 3 groups according to their materials A. Highly corrosion resistant materials such as PTFE, PFA, boron silicate, platinum, etc. Application: Resistant to high-temperature sterilization (121℃), withstand most of the acid, alkali...

Mercredi 19 juin 2019

Hawach Scientific Co., Ltd is main laboratory supplies and industrial filter manufacturing enterprises, from raw materials and production process to ensure the maximum quality monitoring, each batch of a strict quality testing and product warranty. At present, users are distributed...

Mercredi 19 juin 2019

Hawach scientific takes filtration technology as its core and manufactures high-quality filtration products. Our products after years of research and development, the use of advanced technology and first-class production equipment, to provide customers with all kinds of high-quality...